.

Wednesday, January 22, 2014

Wcdma

Chapter 6 WCDMA Chapter 6 6.1 INTRODUCTION This chapter presents the WCDMA air interface, referred also as UMTS terrestrial radio access (UTRA), substantial by the third-generation league project (3GPP). 3GPP has the goal to harmonize and regularise in spot the similar proposals from ETSI, ARIB, TTC, TTA, and T1. Table 6.1 lists the parameters of WCDMA. WCDMA has two modes characterized by the duplex rule: FDD (frequency division duplex) and TDD (time division duplex), for operating with paired and unpaired bands, splitly [1]. The TDD mode is described in Chapter 7. The scat rate of the carcass is 3.84 Mcps. The throw away length is 10 ms and each frame is divided into 15 slots (2560 flake/slot at the chip rate 3.84 Mcps). Spreading elements range from 256 to 4 in the uplink and from 512 to 4 in the downlink. Thus, the respective modulation symbol rates break down from 960 k symbols/s to 15 k symbols/s (7.5 k symbols/s) for FDD uplink. For separati ng bring from the same source, orthogonal variable spreading factor (OVSF) channelization codes are employ. In the downlink, grand codes with a 10-ms point in time (38400 chips at 3.84 Mcps) are used to separate different cells, with the literal code itself length 218-1 chips. In the uplink, Gold codes with a 10ms period, or alternatively short codes with a 256-chip period, are used to separate the different users. For the channel coding tercet options are support: convolutional coding, turbo coding, or no channel coding. highway coding alternative is indicated by upper layers. Bit interleaving is used to randomize infection errors. The modulation scheme is QPSK. The common common aircraft carrier lay has a raster of 200 kHz and can vary from 4.2 to 5.4 MHz. The different carrier spacings can be used to obtain suitable adjoining channel protections depending on the interference scenario. Figure 6.1 shows an example for the floozie bandwidth of 15 MHz wi th three cell layers. Larger carrier spacing! can be applied...If you want to get a full essay, mold it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment